Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 53
___________________________________________________________________________________
___________________________________________________________________________________
SW3-2 ON: To be determined
OFF: No operation (Default)
SW3-3 ON: To be determined
OFF: No operation (Default)
SW3-4 ON: To be determined
OFF: No operation (Default)
The DTI-U40 works only with the SW3-2~SW3-4
Default settings.
SW4/5 SW4 SW5 Termination mode
T1/J1 T1 120Ω T1 mode (Default)
T1/J1 J1 75Ω J1 mode
E1 T1 120Ω E1 mode (120Ω
termination)
E1 J1 75Ω E1 mode (75Ω
termination)
E1 Services are not supported
SW6 Reset Switch
Table 6-19 DTI-U40 Default Switch Settings (Continued)
Switch Setting Description
To Next Page
Loading...
