___________________________________________________________________________________
7 - 20 Installing Electra Elite IPK II KSU Common Optional Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
Table 7-1 PMS-U10 Connectors
Connector Description
COM 1 Used for serial connection to PMS System.
COM 2 Used for serial connection to voice mail.
ETH 0
Used for IP connection to KTS PMS
Configurator software and PMS System.
ETH 1 Not Used.
Default
This pin hole on front of the PMS-U10 has no
label. To default, press and hold with paper
clip, power on unit, wait three seconds and
release.
USB Not Used.
8-pin Connector Not Used.
Table 7-2 PMS-U10 LED Indications
LED Indication
Power Green when power is On.
ETH 0
Green when connected.
Flashing during data transmission
ETH 1 Not Used.
To Next Page
Loading...
