NEC ELECTRA ELITE IPK II - Page 411

Electra Elite IPK II Document Revision 3
System Hardware Manual 9 - 5
___________________________________________________________________________________
___________________________________________________________________________________
3. The Plug Puller shown in Figure 9-4 AC-2R/AC-3R Unit (AC
Adapter) is a hollow cylindrical sleeve with a post and a circular
rim on the base. The plug of the adapter is inserted in this hole,
and the sleeve is pulled over the back of the plug to seat the
post that can then be used to unplug the adapter.
4. Locate the plug on the ancillary device that is connected to the
bottom of the Multiline Terminal and plug in the AC Adapter.
Figure 9-5 Connecting the AC Adapter to an Installed Adapter