___________________________________________________________________________________
10 - 10 Installing Electra Elite Multiline Terminals
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
SECTION 3CONNECTING A DTU/DTP TERMINAL TO THE SYSTEM
The instructions for connecting a Multiline Terminal to the system applies to all
Multiline Terminals.
1. Plug the telephone cord into the modular jack on the bottom side of the Multiline
Terminal. The handset is also attached to the bottom side of the Multiline
Term in al.
2. Lead the telephone and handset cords through the appropriate grooves.
Figure 10-9 Connecting a Multiline Terminal to the System
Figure 10-10 Leading Line Cords on a Multiline Terminal
To Next Page
Loading...
