NEC ELECTRA ELITE IPK II - Page 92

___________________________________________________________________________________
5 - 4 Installing KSUs
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
The Electra Elite IPK II KSU is connected to each of the Multiline Terminals,
Single Line Telephones, optional equipment, CO/PBX, DID, ISDN, 4-wire
E&M Tie lines (Types I and V), and FT1 digital trunks by separate twisted-pair
cable through the MDF. The 4-wire E&M Tie lines, FT1 lines, and ISDN lines
require multiple twisted-pair cabling. Table 5-1 MDF Cable Connections
provides the necessary cabling information.
Figure 5-1 Typical Full MDF Layout
66B50
Type
66M50
Type
Telc o
RJ21X
3 Feet
4 Feet