• The color scheme of the Digital Operator keys was changed.
Operate the keys correctly according to the following information on the displays and colors.
• Install or remove the Digital Operator with the power supply shut off.
Not doing so may result in failure.
Mode key When parameter is
displayed: Moves to the beginning of the next
function mode.
When data is displayed: Cancels the setting and returns to the
parameter display.
In individual input mode: Moves the blinking position one digit to
the left, if not located at the left end. At
the left end, cancels the input data and
returns to the previous display.
Regardless of the display, if you press the Mode key for 3 seconds or
more, the data of Output Frequency Monitor (d001) is displayed.
Enter key When parameter is
displayed: Switches to the data display.
When data is displayed: Enters and stores the set value (into the
EEPROM) and returns to the parameter
display.
In individual input mode: Enters the value in the blinking position
and moves it one digit to the right.
Increment key Increases the parameter number or the set data value. Press and
hold the key to quickly increase the number or value.
Press the increment key and the decrement key simultaneously to
enter the individual input mode, where you can edit the value in each
digit independently.
Decrement key Decreases the parameter number or the set data value. Press and
hold the key to quickly decrease the number or value.
Press the increment key and the decrement key simultaneously to
enter the individual input mode, where you can edit the value in each
digit independently.
Key Name Previous model 3G3RX-V1
RUN key Gray Green
STOP/RESET key Yellow Red
Mode key Blue Blue (No change)
Enter key Yellow Yellow (No change)
Increment key Green Gray
Decrement key Green Gray
Part Name Function
To Next Page
Loading...
