11 Maintenance and Inspection
11 - 2
High-function General-purpose Inverter 3G3RX-V1 User's Manual (SBCE-367)
• Be sure to confirm safety before conducting maintenance, inspection or parts replacement.
• The capacitor service life is influenced by the ambient temperature. Refer to “Smoothing Capacitor
Life Curve” described in the manual. When a capacitor reaches the end of its service life and does
not work as the product, you need to replace the capacitor.
• When disposing of LCD digital operators and wasted batteries, follow the applicable ordinances of
your local government. When disposing of the battery, insulate it using tape.
Do not change wiring and the slide switch (SW1), install/remove the Digital Operator and optional
devices, or replace the cooling fan while the input power is being supplied. Doing so may result in a
serious injury due to an electric shock.
Do not remove the terminal cover during the power supply and 10 minutes after the power shut off.
Doing so may result in a serious injury due to an electric shock.
Do not touch the inverter fins, braking resistors and the motor, which become too hot during the
power supply and for some time after the power shut off. Doing so may result in a burn.
Do not dismantle, repair or modify the product. Doing so may result in an injury.
Precautions for Safe Use
Maintenance and Inspection
The following display must be indicated when products using lithium primary batteries (with
more than 6 ppb of perchlorate) are transport to or through the State of California, USA.
Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
The 3G3AX-OP05 has the lithium primary battery (with more than 6 ppb of perchlorate).
Label or mark the above display on the exterior of all outer shipping packages of your
products when exporting your products which the 3G3AX-OP05 are installed to the State of
California, USA.
WARNING
To Next Page
Loading...
