Omron RX Series - Connections and Functions of CX-Drive; CX-Drive Connection Method

3 Operation and Test Run
3 - 16
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
3-3 Connections and Functions of
CX-Drive
The inverter/Servo support tool CX-Drive is support software to edit the inverter parameter settings.
Installing the OMRON CX-One software on your PC also installs the CX-Drive simultaneously.
The 3G3RX-V1 Series Inverter is supported in the following or higher versions of the CX-Drive product:
• CX-One: Ver. 4.23
• CX-Drive: Ver. 2.7
This section describes how to connect the CX-Drive to an inverter and provides an overview of its
functions.
For details on the functions of the CX-Drive, refer to “CX-Drive Operation Manual (W453)”.
The following figure shows how to connect the 3G3RX-V1 Series with the inverter/Servo support tool
CX-Drive.
Connect the CX-Drive directly to the serial communications port of the inverter.
3-3-1 CX-Drive Connection Method
Direct Connection via Serial Communications
CX-Drive
USB
USB-RS422
Conversion Cable
(Model: 3G3AX-PCACN2)
Connector for
Digital Operator
(A)
(B)
Remove Digital Operator
(A) and Connector (B).