4 Parameter List
4 - 28
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
4-3-3 Group C: Multi-function Terminal Function Parameters
Parameter
No.
Function name Monitor or data range
Default
data
Changes during
operation
Unit Page
Normal
b031 = 10
C001 Multi-function
Input S1 Selection
*1
01: RV (Reverse)
02: CF1 (Multi-step speed setting binary 1)
03: CF2 (Multi-step speed setting binary 2)
04: CF3 (Multi-step speed setting binary 3)
05: CF4 (Multi-step speed setting binary 4)
06: JG (Jogging)
07: DB (External DC injection braking)
08: SET (2nd control)
09: 2CH (2-step acceleration/deceleration)
11: FRS (Free-run stop)
12: EXT (External trip)
13:
USP (Power recovery restart prevention function)
14: CS (Commercial switch)
15: SFT (Soft lock)
16: AT (Analog input switching)
17: SET3 (3rd control)
18: RS (Reset)
20: STA (3-wire start)
21: STP (3-wire stop)
22: F/R (3-wire forward/reverse)
23: PID (PID disabled)
24: PIDC (PID integral reset)
26: CAS (Control gain switching)
27: UP (Remote operation accelerated)
28: DWN (Remote operation decelerated)
29: UDC (Remote data clear)
31: OPE (Forced operator function)
32: SF1 (Multi-step speed setting bit 1)
33: SF2 (Multi-step speed setting bit 2)
34: SF3 (Multi-step speed setting bit 3)
35: SF4 (Multi-step speed setting bit 4)
36: SF5 (Multi-step speed setting bit 5)
37: SF6 (Multi-step speed setting bit 6)
38: SF7 (Multi-step speed setting bit 7)
39: OLR (Overload limit switching)
40: TL (Torque limit enabled/disabled)
41: TRQ1 (Torque limit switching 1)
42: TRQ2 (Torque limit switching 2)
43: PPI (P/PI switching)
44: BOK (Brake confirmation)
45: ORT (Orientation)
46: LAC (LAD cancel)
47: PCLR (Position deviation clear)
48:
STAT (Pulse train position command input permission)
50: ADD (Set frequency A145 addition)
51: F-TM: (Forced terminal block)
52:
ATR (Torque command input permission)
53: KHC (Integrated power clear)
54: SON (Servo ON)
55: FOC (Preliminary excitation)
01 Disabled Enabled – 5-51
C002 Multi-function
Input S2 Selection
18
C003 Multi-function
Input S3 Selection
*1
12
C004 Multi-function
Input S4 Selection
02
C005 Multi-function
Input S5 Selection
03
C006 Multi-function
Input S6 Selection
04
*1 When the emergency shutoff function is enabled (SW1 = ON), the C001 and C003 data are force-rewritten with 18 (RS)
and 64 (EMR), respectively. 64 cannot be set by the user. If you turn ON and then OFF the slide switch SW1, C003 is
set to no (No allocation).
To Next Page
Loading...
