4 - 29
4 Parameter List
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
4-3 Extended Function Mode
4
4-3-3 Group C: Multi-function Terminal Function Parameters
Parameter
No.
Function name Monitor or data range
Default
data
Changes during
operation
Unit Page
Normal
b031 = 10
C007 Multi-function
Input S7 Selection
56: MI1 (General-purpose input 1)
57: MI2 (General-purpose input 2)
58: MI3 (General-purpose input 3)
59: MI4 (General-purpose input 4)
60: MI5 (General-purpose input 5)
61: MI6 (General-purpose input 6)
62: MI7 (General-purpose input 7)
63: MI8 (General-purpose input 8)
65: AHD (Analog command held)
66: CP1 (Position command selection 1)
67: CP2 (Position command selection 2)
68: CP3 (Position command selection 3)
69: ORL (Zero return limit signal)
70: ORG (Zero return startup signal)
71: FOT (Forward driving stop)
72: ROT (Reverse driving stop)
73: SPD (Speed/Position switching)
74: PCNT (Pulse counter)
75: PCC (Pulse counter clear)
82:
PRG (DriveProgramming start)
no: NO (No allocation)
05 Disabled Enabled – 5-51
C008 Multi-function
Input S8 Selection
06
C011 Multi-function
Input S1
Operation
Selection
00: NO (Normally open contact)
01: NC (Normally closed contact)
00 Disabled Enabled – 5-52
C012 Multi-function
Input S2
Operation
Selection
00: NO (Normally open contact)
01: NC (Normally closed contact)
00
C013 Multi-function
Input S3
Operation
Selection
00: NO (Normally open contact)
01: NC (Normally closed contact)
00
C014 Multi-function
Input S4
Operation
Selection
00: NO (Normally open contact)
01: NC (Normally closed contact)
00
C015 Multi-function
Input S5
Operation
Selection
00: NO (Normally open contact)
01: NC (Normally closed contact)
00
C016 Multi-function
Input S6
Operation
Selection
00: NO (Normally open contact)
01: NC (Normally closed contact)
00
C017 Multi-function
Input S7
Operation
Selection
00: NO (Normally open contact)
01: NC (Normally closed contact)
00
C018 Multi-function
Input S8
Operation
Selection
00: NO (Normally open contact)
01: NC (Normally closed contact)
00
C019 Forward RUN
Command FW
Operation
Selection
00: NO (Normally open contact)
01: NC (Normally closed contact)
00
To Next Page
Loading...
