Omron RX Series - Data Display

3 - 7
3 Operation and Test Run
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
3-1 Operation of Digital Operator
3
3-1-2 Key Operation Method
The following figure shows how to operate the Digital Operator to reach the intended parameter display.
Transition of Parameter Display
Monitor Mode “d”
Parameter display
On the parameter display
: Moves to Data display.
Data display
Data cannot be changed in
the monitor mode “d”.
d001: Output Frequency Monitor
On the parameter display
On the parameter display
: Moves to the next mode.
Stores
Data display
F001: Output Frequency Setting
On the data display (F001 to F*03)
Changes are entered instantaneously, so the value does not blink.
: Press this to store the value to the EEPROM and return to the parameter display.
: Press this to return to the parameter display, without storing the value to the EEPROM.
Function Mode “F”
Parameter display
Extended Function Mode “A”
Parameter display
Data display
A001: Frequency Reference Selection
On the data display
All digits of the value blink after each change.
While the digit is blinking, the changes are not reflected.
Extended Function Mode “C”
Extended Function Mode “H”
Extended Function Mode “b”
Extended Function Mode “P”
Extended Function Mode “U”
Monitor Mode “d”
Returns to d001.
:
Press this to enter and store the value and return to the parameter display.
:
Press this to discard the changes and return to the parameter display.
Note
*1
*2
Use the Increment/Decrement key to increase or decrease
a parameter number. Pressing the Increment key at the
end of mode returns to the beginning of the same mode.
*1 Data cannot be changed in the monitor mode “d”.
*2 After the extended function mode “U”, returns to the monitor
mode “d”.
In the parameter display or data display
mode, pressing the Increment and
Decrement keys simultaneously enables
quick change of the parameter data.
For details, refer to Individual Input Mode
(Direct Input or Selection) on page 3-10.