Omron RX Series - Page 124

3 Operation and Test Run
3 - 8
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
In the extended function mode U, you can operate the Digital Operator in the same way as in other modes.
However, do not be confused although each parameter number is displayed again for the set value.
Press the Enter key to enter the selected parameter number. Then the display returns to the parameter
display in the extended function mode U.
To display only the user set parameters, set the Display Selection (b037) to 02 (User setting).
Transition of Parameter Display and Key Operation in Function Group U
or
Extended Function
Mode A
Extended Function
Mode P
Extended Function
Mode H
Extended Function
Mode U
Extended Function
Mode C
Extended Function
Mode B
Monitor
Mode
Function
Mode
(Factory setting)
Press the Enter key to enter the
selected parameter number in “U”.
Pressing the Enter key does not
return.