Omron RX Series - Preparing Backing Plate

2 - 13
2 Design
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
2-2 Removal of Each Part
2
2-2-3 Preparing Backing Plate
When wiring cables, cut the points between the backing plate and unnecessary portions with nippers or
a wire cutter, and remove.
 For connection without any cable conduit
Make an X-cut in each rubber bushing of the backing plate with nippers or a wire cutter, and insert a
cable.
 For connection with a cable conduit
Remove the rubber bushing from each portion where you connect the cable conduit.
Precautions for Safe Use
Do not remove the rubber bushing unless you connect a cable conduit. Doing so may result in
damage to the cable sheath by the inner edge of the backing plate, resulting in a short-circuit or
ground fault.
2-2-3 Preparing Backing Plate
Inverter with 22 kW or Lower Capacity
Inverter with 30 kW or Higher Capacity
Connecting points
Unnecessary portion
Backing plate
Rubber bushing