Omron RX Series - Page 189

4 - 43
4 Parameter List
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
4-3 Extended Function Mode
4
4-3-5 Group P: Option Parameters
P027 Speed Deviation
Excessive Level
0.00 to 99.99
100.0 to 120.0
7.50 Disabled Enabled Hz 6-17
P028 Motor Gear Ratio
Numerator
1. to 9999. 1. Disabled Enabled – 6-17
P029 Motor Gear Ratio
Denominator
1. to 9999. 1. Disabled Enabled –
P031 Acceleration/
Deceleration Time
Input Type
00: Digital Operator
01: Option 1
02: Option 2
03: DriveProgramming
00 Disabled Disabled – 5-35
P032 Orientation Stop
Position Input
Type
00: Digital Operator
01: Option 1
02: Option 2
00 Disabled Enabled – 7-83
P033 Torque Reference
Input Selection
00: Terminal FV
01: Terminal FI
02: Terminal FE
03: Digital Operator
06: Option
00 Disabled Disabled – 6-56
P034 Torque Reference
Setting
0. to 200. (0.4 to 55 kW)
0. to 180. (75 to 132 kW)
0. Enabled Enabled %
P035 Polarity Selection
at Torque
Reference via FE
00: Signed
01: Depends on the RUN direction
00 Disabled Enabled –
P036 Torque Bias Mode 00: None
01: Digital Operator
02: Terminal FE
00 Disabled Enabled –
P037 Torque Bias Value –200. to 200. (0.4 to 55 kW)
–180. to 180.
(75 to 132 kW)
0. Enabled Enabled %
P038 Torque Bias
Polarity Selection
00: Signed
01: Depends on the RUN direction
00 Disabled Disabled –
P039 Speed Limit Value
in Torque Control
(Forward)
0.00 to 1st Maximum Frequency
(A004)
0.00 Disabled Enabled Hz
P040 Speed Limit Value
in Torque Control
(Reverse)
0.00 to 1st Maximum Frequency
(A004)
0.00 Disabled Enabled Hz
P044 Communications
Error Detection
Timer Setting
0.00 to 99.99 1.00 Disabled Disabled s 7-147
P045 Operation
Selection at Host
Communications
Error
00: Trip
01: Trip after deceleration stop
02: Ignore
03: Free-run stop
04: Deceleration stop
00 Disabled Disabled –
P046 Assembly
Instance Number
0 to 20 1 Disabled Disabled –
P048 Operation
Selection at Idle
Mode Detection
00: Trip
01: Trip after deceleration stop
02: Ignore
03: Free-run stop
04: Deceleration stop
00 Disabled Disabled –
Parameter
No.
Function name Monitor or data range
Default
data
Changes during
operation
Unit Page
Normal b031 = 10
Options