Omron RX Series - Page 584

10 Troubleshooting
10 - 10
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
Additional Information
Refer to the “MX2/RX Series EtherCAT Communication Unit User’s Manual (I574)”.
Additional Information
Refer to the “MX2/RX Series CompoNet Communications Unit User’s Manual (I582)”.
Protective Function Display when EtherCAT Communications Unit
(Model: 3G3AX-RX-ECT) is Mounted
Description
Alarm code on
Digital Operator
When an unrecoverable error is detected in the option board, a trip is generated for the
inverter.
E70.
A trip occurs when a timeout is generated in communication between the inverter and
option board.
E79.
Protective Function Display when CompoNet Communications Unit
(Model: 3G3AX-RX-CRT-E) is Mounted
Description
Alarm code on
Digital Operator
This alarm appears if a fatal fault occurs on the communications unit when the power
supply is ON or during opertaion.
E70.
This alarm appears if an overlapping node address is found. E71.
This alarm appears if the inverter trips due to an external fault (EXT) detected via the
fieldbus connection.
E72.
This alarm appears if a communications idle error or communications timeout error is
detected in the RUN mode.
E73.
This alarm appears if a setting error is detected in any of the parameters P160 to P167
and P170 to P179.
E74.
This alarm appears if the inverter settings are not compatible with the communications
unit.
E75.
This alarm appears if an option connection error or a fatal fault is detected when the
communications unit operates.
E79.