EasyManuals Logo

Quantum Scalar i2000 User Manual

Quantum Scalar i2000
447 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
Chapter 3 Description
Mixed Media Support and Rules
Scalar i2000 User’s Guide 98
• When purchasing a library with mixed media, the new orders must
specify the base system technology (either LTO or DLT) and the
number of magazines, the number of drives, and the number of I/E
station magazines for each media type required. The base system is
considered the primary media type used in the library.
• Multiple media can be mixed at the magazine level.
• The supported multiple media are LTO-1, LTO-2, LTO-3, LTO-3
WORM, LTO-4, LTO-4 WORM, SDLT-320, SDLT-600, DLT-S4.
• If you are loading cartridges into the library by using the I/E station,
you must have a magazine of each of the two types of media in the I/
E station (LTO and DLT).
• Mixed media can be within the 100 slot capacity increment, with the
following restrictions:
• DLT must be ordered in multiples of five because the magazines
hold five cartridges.
• LTO must be ordered in multiples of six because the magazines
hold six cartridges.
• Regardless of the mixed quantities of each media type, the total
slots licensed will still be in multiples of 100.
• Field upgrades of the library to existing single media systems must
specify a mixed media picker kit if mixed media will be used in the
upgraded library.
• Drive types can be installed in any order. For example, an LTO drive
can occupy the first drive position, a DLT drive can occupy the
second, and another LTO can occupy the third drive position.
However, drives must be installed beginning in the lower most drive slot
of the control module. Once the control module has 12 drives installed
from bottom to top, you must move to the bottom drive position of the
first expansion module.
• The library must include at least one drive for each type of cartridge
used.
• Magazines must be installed in the control module beginning with
the back rack (drive side). Once the back rack (drive side) is full, you
must then install magazines in the door side, starting with the top left
corner. See
figure 18.
• The secondary media type is installed beginning at storage slot 4096
or the first media magazine. See
figure 18.

Table of Contents

Other manuals for Quantum Scalar i2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quantum Scalar i2000 and is the answer not in the manual?

Quantum Scalar i2000 Specifications

General IconGeneral
BrandQuantum
ModelScalar i2000
CategoryStorage
LanguageEnglish

Related product manuals