Chapter 4 Configuring Your Library
Using LDAP
Scalar i2000 User’s Guide 192
• SNMP — To prevent all SNMP traffic across the MCB Ethernet
port, select Disable. To allow SNMP GET operations, select
Enable.
If SNMP traffic is allowed, then SNMP v3 is always available. If you want
to permit less secure SNMP access, select Enable SNMP v1 and v2. If you
decide you do not want to use SNMP v1 and v2, clear the Enable SNMP
v1 and v2 check box.
The library ignores all remotely issued SNMP SET operations under any
circumstance, which means that external applications cannot register
themselves to receive SNMP traps from the library. However, the Trap
Registration dialog box (Setup→ Trap Registration) enables you to
perform this registration yourself by entering the necessary IP and port
information. For more information about the Trap Registration dialog
box, see
Registering SNMP Traps on page 184.
3 If you want to apply the changes, but you do not want to close the
dialog box, click Apply. Otherwise, click OK to apply the changes
and close the dialog box.
Using LDAP
Lightweight Directory Access Protocol (LDAP) is the industry standard
Internet protocol that provides centralized user account management.
This library supports the Microsoft
®
Active Directory
®
LDAP server and
user account information in the schema defined by RFC 2307. User
password schemes must be encrypted using UNIX® crypt.
When setting up a user account in Microsoft Active
Directory, make sure to populate the UNIX
attributes with information. This requires all
Active Directory users to be part of an NIS
Domain, or have NIS Domain information entered.
To Next Page
Loading...
Need help?
General