Quantum Scalar i2000

Chapter 5 Maintaining Your Library
Monitoring the Library
Scalar i2000 User’s Guide 208
Monitoring Drive Status 5
The Drive Status dialog box displays status information for tape drives in
the currently selected partition. If you are working in the physical library,
status information for all drives appears. You can perform this procedure
while viewing either the physical library or a partition.
1 Click Monitor→ Drives.
The Drive Status dialog box appears.
The following table describes the elements on the Drive Status dialog box.
Element Description
Type The type of drive.
WWN For a Fibre drive only, the World Wide Name of the drive.
SCSI ID For a SCSI drive only, the SCSI ID of the drive.
RAS The status of the drive as reported by the RAS system (for example, Good or
Failed).
Firmware level The firmware level of the drive.
Media ID The barcode of the loaded cartridge.