Chapter 4 Configuring Your Library
Specifying the Date and Time
Scalar i2000 User’s Guide 139
The Date and Time dialog box appears.
4 In the Date and Time dialog box, you can set the following
parameters:
• If you want to use NTP, in the NTP Setting field, select Enable. The
default is Disable.
If you choose to use NTP, you must provide valid IP addresses that are
accessible from the library. You have the option of using one or two IP
addresses.
If NTP is enabled and you no longer want to use this setting, select
Disable.
• If you do not use NTP, you must manually set the date and time.
In the Date drop-down lists, click the appropriate month, date, and year.
In the Time drop-down lists, click the appropriate hour, minute, and AM
or PM.
To Next Page
Loading...
Need help?
General