Chapter 4 Configuring Your Library
Configuring Library Security
Scalar i2000 User’s Guide 190
• Callback Port Range — To configure firewall access for server
callbacks to remote clients, type the first port number of a range
of ports that you want to be used for callbacks in the Starting text
box, and then type the last port number in the Ending text box.
Valid port ranges must fit within the range 1024 to 65535. Remote
client service ports must be within the range of ports specified
here. Otherwise, callbacks fail because the library’s firewall
blocks outbound packets designated for out-of-range ports.
• Service Login — To allow service login, select Enable. To
prevent service login, select Disable. The Admin user can enable
or disable the service user login on both the front panel access
and the remote client access.
• Session — To configure the length of the session’s timeout, type
or use the arrow buttons to specify the length of a session before
it times out. Valid session timeouts are 1-1440 minutes (1 minute -
24 hours), where the default is 30 minutes.
3 If you want to apply the changes, but you do not want to close the
dialog box, click Apply. Otherwise, click OK to apply the changes
and close the dialog box.
Enabling SSL can impact the network performance
of remote operations (for example, downloading
new library software).
The default service login through the service port
is still available for use. For security purposes, the
service port can be physically locked down by
locking the back door of the i2000.
To Next Page
Loading...
Need help?
General