Chapter 6 Running Your Library
Logging On and Off
Scalar i2000 User’s Guide 339
2 In the Name text box, type the name of the user or administrator
account with which you want to log on. If you want to log on with the
default administrator account, type admin.
3 Position the cursor in the text box below the Name text box by
tapping it, and then type the password for the user or administrator
account.
4 After you type a user name and password, select OK.
User names and passwords are case-sensitive.
Select the Shift key to display uppercase letters
and special characters. This enables you to type
one uppercase letter or special character before the
Scalar i2000 Logon dialog box returns to
displaying lowercase characters. To type more
than one uppercase character or special character,
select the Caps key. The Caps key toggles between
displaying uppercase and lowercase characters.
Only one administrator at any given time can be
logged on to the library.
If you want to log on using the default
administrator account (admin), and you do not
remember the password, contact technical support
to reset the password.
If you are logging on to the library for the first time
using the default administrator account (admin),
type password. After you log on, the library
prompts you to change the default admin
password. You must enter and confirm a new
password. Passwords that are most secure include
a combination of letters, numbers, and non-
alphanumeric characters. Passwords must be eight
or more characters in length. The word
“password” is not available for use.
To Next Page
Loading...
Need help?
General