R&S ZNL Series - Page 380

VNA GUI reference
R&S
®
ZNL/ZNLE
380User Manual 1178.5966.02 ─ 20
Remote command:
CALCulate<Chn>:STATistics:NLINear:COMP[:STATe]
CALCulate<Chn>:STATistics:NLINear:COMP:LEVel
CALCulate<Chn>:STATistics:NLINear:COMP:PHASe
CALCulate<Chn>:STATistics:NLINear:COMP:RESult?
CALCulate<Chn>:STATistics[:STATe]:AREA
Reference Value
(R&S ZNL only)
This control is only available if compression point statistics are calculated. It selects the
reference value ("small signal value") for the compression point calculation.
"First Point"
(default)
uses the value at the first point of the selected evaluation range as
the reference value (see Chapter 10.6.8.2, "Evaluation Range dialog",
on page 381)
"Selected
Marker"
uses the value at a selectable marker as the reference value (see
"Selected Marker" on page 380)
"Range"
uses the average value in a configurable "Ref. Range" on page 380
as the reference value
"Defined
Value"
allows to specify the reference value manually (see "Defined Value"
on page 381)
Remote command:
CALCulate<Chn>:STATistics:NLINear:COMP:REFerence
Selected Marker
(R&S ZNL only)
This button is only visible if "Selected Marker" is used as Reference Value. It allows
you to select the marker whose value shall be used as the reference ("small signal
value") for the compression point calculation.
Remote command:
CALCulate<Chn>:STATistics:NLINear:COMP:RMARker
Ref. Range
(R&S ZNL only)
This button is only visible if "Range" is used as Reference Value.
It opens the "Reference Range" dialog that allows you to configure the sweep range
whose average value shall be used as the reference ("small signal value") for the com-
pression point calculation.
Trace softtool