R&S ZNL Series User Manual

VNA GUI reference
R&S
®
ZNL/ZNLE
527User Manual 1178.5966.02 ─ 20
CONFigure:TRACe<Trc>:CHANnel:NAME?
CONFigure:TRACe<Trc>:CHANnel:NAME:ID?
New Channel + Diagram
Creates a channel and a trace with default settings, and assigns the created trace to a
new diagram area.
The new channel is named Ch<n>, where <n> is the largest of all existing channel
numbers plus one. The name can be changed in the "Channel Manager" dialog.
Tip: To create a channel and a trace with default settings and to display the trace in the
active diagram area, use New Channel.
Copy Channel + Diagram
Copies the active channel with all its settings (including a possible channel calibration)
and traces, and displays the created traces in a new diagram area.
The new channel is named Ch<n>, where <n> is the largest of all existing channel
numbers plus one. The name can be changed in the "Channel Manager" dialog.
Tips: Use Copy Channel to display the new traces in an existing diagram area.
Delete Channel
Deletes the current channel including all the traces assigned to it and removes all dis-
play elements related to the channel from the diagram area. "Delete Channel" is dis-
abled if the channel setup contains only one channel: In manual control, each channel
setup must contain at least one diagram area with one channel and one trace.
Tips: Use the "Undo" function to restore a channel that was unintentionally deleted.
Remote command:
CONFigure:CHANnel<Ch>[:STATe] OFF
Channel On
Toggles the measurement state of the active channel.
Remote command:
CONFigure:CHANnel<Ch>:MEASure[:STATe]
Only Active Channel On
If checked, only the active channel is measured; all other channels are switched off
temporarily and dynamically.
Temporarily means: If "Only Active Channel On" is unchecked, then all channels return
to their original Channel On state.
Dynamically means: If another channel becomes the active one, the firmware adjusts
the temporary ON/OFF state accordingly.
Remote command:
CONFigure:CHANnel:MEASure:ACTive[:STATe]
Fixture Simulator
The "Fixture Simulator" switch deactivates or activates the configured deembedding,
embedding, balanced ports, and port impedance settings for the selected channel.
Channel softtool

R&S ZNL Series Specifications

General

Brand	R&S
Model	ZNL Series
Category	Measuring Instruments
Language	English