R&S ZNL Series - Page 537

VNA GUI reference
R&S
®
ZNL/ZNLE
537User Manual 1178.5966.02 ─ 20
Move Up / Move Down
Allows you to modify the sequence in which the active port set deembeddings/embed-
dings are applied.
Add / Delete
Allows you to define the "Port Sets" to whom a deembedding or embedding network
can be assigned.
The "Add" button opens the "Define Port Set" dialog that allows you to define an addi-
tional port set, comprising two ports (in arbitrary order).
Use the controls on the right-hand side of the dialog to define the port set and the order
of the ports within the port set.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:PPAir:DEEMbedding<ListId>:
DEFine
CALCulate<Ch>:TRANsform:VNETworks:PSET:DEEMbedding<ListId>:
DEFine
CALCulate<Ch>:TRANsform:VNETworks:PPAir:DEEMbedding:DELete
CALCulate<Ch>:TRANsform:VNETworks:PPAir:EMBedding<ListId>:DEFine
CALCulate<Ch>:TRANsform:VNETworks:PSET:EMBedding<ListId>:DEFine
CALCulate<Ch>:TRANsform:VNETworks:PPAir:EMBedding<ListId>:DELete
Active
The checkboxes in the "Active" column activate or deactivate the configured de-/
embeding for the related port set (i.e. adds or removes it to/from the calculation flow)
without changing its parameters.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:PPAir:DEEMbedding<ListId>[:
STATe]
CALCulate<Ch>:TRANsform:VNETworks:PPAir:EMBedding<ListId>[:
STATe]
File Name <i>/Inc. Seq. <i>/Swap Gates <i>
The "File Name 1" (and "File Name 2") buttons are enabled as long as the selected
deembedding/embedding Port Sets tab is defined using one or two Touchstone file(s).
Offset Embed softtool