R&S ZNL Series - Page 540

VNA GUI reference
R&S
®
ZNL/ZNLE
540User Manual 1178.5966.02 ─ 20
This panel can also be activated by selecting the Ground Loop tab softtool tab. Refer
to its description for background information, parameters and additional remote com-
mands.
Active
The checkboxes in the "Active" column activate or deactivate the configured ground
loop deembedding/embedding (i.e. adds or removes it to/from the calculation flow)
without changing its parameters.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:GLOop:DEEMbedding[:STATe]
CALCulate<Ch>:TRANsform:VNETworks:GLOop:EMBedding[:STATe]
File Name 1
The ellipsis button in the "File Name 1" column is enabled if a 1-port data Network net-
work (*.s1p file) is selected.
Note: The loaded S-parameter trace is stored in the active channel setup. Persisted
channel setups contain the full embedding and deembedding data so that they can be
transferred to other instruments.
Remote command:
MMEMory:LOAD:VNETworks<Ch>:GLOop:DEEMbedding
MMEMory:LOAD:VNETworks<Ch>:GLOop:EMBedding
10.14.1.7 Impedance Renormalization panel
This panel provides alternative access to the reference impedance settings (see "Ref-
erence Impedance tab" on page 400).
Access: Overview panel > "Impedance Renor."
Offset Embed softtool