R&S ZVB - Page 1031

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 1016
<Ch>
Calibrated channel number. This parameter is ignored; the verification is either
enabled or disabled for all channels.
<Pt>
Calibrated port number. This parameter is ignored; the verification is either
enabled or disabled for all sources.
<Boolean>
Enables (ON) or disables (OFF) the verification sweep.
*RST value
ON
SCPI,
Command
Types
Device-specific, command or query
Example:
See SOURce<Ch>:POWer<Pt>:CORRection[:ACQuire],
SOURce<Ch>:POWer<Pt>:CORRection[:ACQuire]:VERification:RESult?
SOURce<Ch>:POWer<Pt>:CORRection:COLLect:AVERage[:COUNt] <readings>
Sets a limit for the number of calibration sweeps in the source power calibration. The command is valid for
all channels, ports and external generators. Equivalent command:
SOURce<Ch>:POWer<Pt>:CORRection:NREadings.
<Ch>
Calibrated channel number. This parameter is ignored; the limit applies to all
channels.
<Pt>
Calibrated port number. This parameter is ignored; the limit applies to all
sources.
<readings>
Number of readings
Range [def. unit]
1 to 100 [–]
*RST value
1
SCPI, Command
Types
Device-specific, command or query
Example:
See SOURce<Ch>:POWer<Pt>:CORRection[:ACQuire] (for equivalent command
SOURce<Ch>:POWer<Pt>:CORRection:NREadings).
SOURce<Ch>:POWer<Pt>:CORRection:COLLect:AVERage:NTOLerance
<tolerance>
Specifies the maximum deviation of the measured power from the target power of the calibration. The
command is valid for all channels and calibrated ports.
<Ch>
Calibrated channel number. This parameter is ignored; the tolerance value is
valid for all sources.
<Pt>
Calibrated port number. This parameter is ignored; the tolerance value is valid
for all sources.
<tolerance>
Tolerance value
Range [def. unit]
0.001 dB to 1000 dB [dB]
*RST value
1 dB
SCPI, Command
Device-specific, command or query