R&S ZVB - Page 633

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 618
CALCulate<Chn>:DLINe:STATe <Boolean>
Switches the horizontal line on or off.
<Chn>
Channel number used to identify the active trace.
<Boolean>
ON | OFF - horizontal line on or off
*RST value
OFF
SCPI, Command Types
Device-specific, command or query.
Example:
See CALC:DLIN.
CALCulate<Chn>:FILTer[:GATE]...
This subsystem defines the properties of the time gate which is used to optimize the time domain
response (with option ZVAB-K2, Time Domain).
CALCulate<Chn>:FILTer[:GATE]:TIME:CENTer <numeric_value>
Defines the center time of the time gate.
<Chn>
Channel number used to identify the active trace.
<numeric_value>
Center time of the time gate
Range [def. unit]
-99.8999999 s to +99.8999999 s. The increment (parameters UP or
DOWN) is 0.1 ns. [s]
*RST value
1.5E-009 s
SCPI, Command
Types
Confirmed, command or query
Example:
*RST; :CALC:TRAN:TIME:STAT ON; :CALC:FILT:TIME:STAT ON
Reset the instrument and enable the time domain representation and the
time gate.
CALC:FILT:TIME:CENT 0; SPAN 5ns
Set the center time to 0 ns and the time span to 5 ns.
CALCulate<Chn>:FILTer[:GATE]:TIME:DCHebyshev <numeric_value>
Sets the sideband suppression for the Dolph-Chebyshev time gate. The command is only available if a
Dolph-Chebyshev time gate is active (CALCulate<Chn>:FILTer[:GATE]:TIME:WINDow
DCHebyshev).
<Chn>
Channel number used to identify the active trace.
<numeric_value>
Sideband suppression