R&S ZVB - Page 673

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 658
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute NPEak.
<Chn>
Channel number used to identify the active trace
<Mk>
Marker number in the range 1 to 10
Range [def. unit]
– [–]
*RST value
–
SCPI, Command Types
Device-specific, no query
CALCulate<Chn>:MARKer<Mk>:SEARch:RIGHt
[Deprecated command]
Selects a search mode for marker no. <Mk> and initiates a search for the next valid peak to the right. The
marker must be created before using CALCulate<Chn>:MARKer<Mk>[:STATe] ON.
Note: This command is the ZVR-compatible equivalent of
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute RPEak.
<Chn>
Channel number used to identify the active trace
<Mk>
Marker number in the range 1 to 10
Range [def. unit]
– [–]
*RST value
–
SCPI, Command Types
Device-specific, no query
CALCulate<Chn>:MARKer<Mk>:SEARch:TRACking <Boolean>
Enables or disables the marker tracking mode for marker no. <Mk>. Tracking mode causes the active
minimum/maximum or target search of the active marker to be repeated after each sweep. A marker must
be created and a search mode must be active (CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute
...) to use this command.
If the current search mode is a bandfilter search this command enables or disables bandfilter tracking.
<Chn>
Channel number used to identify the active trace
<Mk>
Marker number in the range 1 to 10. For a bandfilter search (BFILter) this
numeric suffix is ignored and may be set to any value because the bandfilter
search functions always use markers M 1 to M 4.
<Boolean>
ON | OFF - Enables or disables the marker tracking mode.
*RST value
OFF
SCPI,
Command
Types
Device-specific, command or query
Example:
Suppose that the active setup contains an active trace no. 1.
CALC:MARK ON; :CALC:MARK:FUNC:EXEC MAXimum
Create marker no. 1 and assign them to trace no. 1. Activate a maximum search