R&S ZVB - Page 708

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 693
Select a resolution enhancement factor of 3 in order to improve the resolution
in time domain.
CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam:CONTinuous <Boolean>
Determines whether continuous extrapolation for the DC value is enabled.
<Chn>
Channel number used to identify the active trace
<Boolean>
ON – Continuous extrapolation enabled
OFF – Continuous extrapolation disabled
*RST value
ON [–]
SCPI, Command Types
Device-specific, command or query
Example:
See CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam
CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam:EXTRapolate
Extrapolates the measured trace towards f = 0 and overwrites the current DC value
(CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam). The command is relevant for lowpass time
domain transforms.
<Chn>
Channel number used to identify the active trace
Parameters
None
*RST value
–
SCPI, Command Types
Device-specific, no query (the command causes an event)
Example:
See CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam
CALCulate<Chn>:TRANsform:TIME:LPFRequency
Calculates the harmonic grid for lowpass time domain transforms, keeping the stop frequency and the
number of points.
Use CALCulate<Chn>:TRANsform:TIME:LPASs if you wish to use one of the other algorithms for
calculating the grid.
<Chn>
Channel number used to identify the active trace
Parameters
None
*RST value
–
SCPI, Command Types
Device-specific, no query (the command causes an event)
Example:
See CALCulate<Chn>:TRANsform:TIME[:TYPE]