R&S ZVB - Page 842

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 827
N50, N75: N 50 Ω or N 75 Ω connectors
PC7, PC35, PC292: PC 7, PC 3.5 or 2.92 mm connectors
USER<no>: User-defined connectors UserConn1, UserConn2
SMA: User-defined connector type SMA ...
'<ckit_name>'
String parameter containing the name of a calibration kit available on the
analyzer.
'<ckit_label>'
String parameter containing the label of a calibration kit available on the analyzer,
usually the serial number.
*RST value
– (A *RST does not change the assignment between connector types and
calibration kits.)
SCPI, Command
Types
Device-specific, command or query
Example:
MMEM:LOAD:CKIT 'C:\Program Files\Rohde&Schwarz\Network
Analyzer\Calibration\Kits\New_kit (123456).calkit'
Load the previously created cal kit file New_kit
(123456).calkit from the default cal kit directory.
CORR:CKIT:N50:LSEL 'New_kit', '123456'
Assign the imported kit to the N 50 Ω connector type (assuming that the cal kit
name stored in New_kit (123456).calkit reads New_kit and that its label
reads 123456).
[SENSe<Ch>:]CORRection:CKIT:LCATalog? '<conn_name>'
Returns a list of all cal kits and their labels for a given connector type.
<Ch>
Channel number. This suffix is ignored because cal kits are channel-
independent.
<conn_name>
Name of the connector type. Use
SENSe<Ch>:CORRection:CONNection:CATalog? to query connector
names.
*RST value
–
SCPI, Command
Types
Device-specific, query only
Example:
See SENSe<Ch>:CORRection:CONNection:CATalog?
[SENSe<Ch>:]CORRection:CKIT:LDELete '<ckit_name>', '<ckit_label>'
Deletes an imported or user-defined cal kit which is identified by its cal kit name and label.
It is not possible to modify or store predefined or ideal kits.
<Ch>
Channel number. This suffix is ignored because calibration kits are channel-
independent.
'<ckit_name>'
String parameter containing an imported or user-defined calibration kit
available on the analyzer.