R&S ZVB - Page 883

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 868
SCPI, Command
Types
Device-specific, no query
Example:
*RST; :CORR:LOSS:AUTO ONCE
Reset the instrument and apply the Auto Length and Loss function to the
default trace (Trc1 in channel 1).
[SENSe<Ch>:]CORRection:LOSS<port_no>:FREQuency <ref_frequency>
Defines the reference frequency for the frequency-dependent part of the offset loss
([SENSe<Ch>:]CORRection:LOSS<port_no>).
<Ch>
Channel number of the offset-corrected channel
<port_no>
Port number of the analyzer
<ref_frequency>
Reference frequency
Range [def. unit]
Frequency range of the analyzer model [Hz]. The increment (UP/DOWN) is
1 MHz.
*RST value
1000000000 Hz (= 1 GHz)
SCPI, Command
Types
Device-specific, command or query
Example:
See [SENSe<Ch>:]CORRection:EDELay<port_no>:ELENgth
[SENSe<Ch>:]CORRection:LOSS<port_no>:OFFSet <DC_loss>
Defines the frequency-independent part (DC value) of the offset loss.
<Ch>
Channel number of the offset-corrected channel
<port_no>
Port number of the analyzer
<DC_loss>
Frequency-independent part of the offset loss
Range [def. unit]
-200 dB to +200 dB [dB]. The increment (UP/DOWN) is 0.001 dB.
*RST value
0 dB
SCPI, Command Types
Confirmed, command or query
Example:
See [SENSe<Ch>:]CORRection:EDELay<port_no>:ELENgth
[SENSe<Ch>:]CORRection:NFIGure[:STATe] <Boolean>
Disables or enables the Noise Figure Calibration for the active channel <Ch>.
<Ch>
Channel number
<Boolean>
OFF - Disable calibration (select Correction Off)
ON - (re-)enable calibration
*RST value
OFF (calibration disabled, no noise figure calibration available after a