R&S ZVB - Page 904

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 889
[SENSe<Ch>:]FREQuency:CONVersion:HARMonic:ORDer <order>
Selects the order of the harmonic measured if a harmonic measurement is enabled
([SENSe<Ch>:]FREQuency:CONVersion HARMonic).
<Ch>
Channel number.
<order>
Order of the harmonic, integer multiple of the fundamental frequency
measured.
Range [def. unit]
2 to 100 [–].
*RST value
2
SCPI, Command
Types
Device-specific, command or query.
Example:
See [SENSe<Ch>:]FREQuency:CONVersion
[SENSe<Ch>:]FREQuency:CONVersion:HARMonic:RELative <Boolean>
Enables or disables the relative harmonic measurement where the harmonic is divided by the fundamental
wave.
With enabled relative measurement the analyzer creates a new channel and a new (mathematical)
trace; see program example for [SENSe<Ch>:]FREQuency:CONVersion.
<Ch>
Channel number.
<Boolean>
Enable (ON) or disable (OFF) the relative harmonic measurement.
*RST value
OFF
SCPI, Command Types
Device-specific, command or query.
Example:
See [SENSe<Ch>:]FREQuency:CONVersion
[SENSe<Ch>:]FREQuency:CONVersion:HARMonic:RPORt <port_no>
Selects the receive port for the harmonic measurement.
<Ch>
Channel number.
<port_no>
Integer port number.
Range [def. unit]
Depending on the analyzer model [–].
*RST value
2
SCPI, Command Types
Device-specific, command or query.
Example:
See [SENSe<Ch>:]FREQuency:CONVersion