R&S ZVB - Page 920

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 905
Types
Example:
*RST; FREQ:IMOD:LTON PORT,1
Select port 1 as a source port for the lower tone.
FREQ:IMOD:UTON PORT,3
Select port 3 as a source port for the upper tone.
FREQ:IMOD:COMB ON
Enable internal combiner.
[SENSe<Ch>:]FREQuency:IMODulation:CONVersion OFF
Disables the intermodulation measurement and switches back to normal (non frequency-converting)
mode.
<Ch>
Channel number.
OFF
Disable intermodulation measurement
*RST value
OFF
SCPI, Command Types
Device-specific, no query.
Example:
See [SENSe<Ch>:]FREQuency:IMODulation:LTONe
[SENSe<Ch>:]FREQuency:IMODulation:LTONe PORT, <source_no>
Selects the source for the lower tone signal that is used for the intermodulation measurement. Please note
that external generators are not allowed to drive the lower tone signal.
<Ch>
Channel number.
Parameters
Lower tone source:
PORT – internal source at port <source_no>
<source_no>
Number of the internal port
Range [def. unit]
1 to port number of the analyzer [–]
*RST value
– (for all parameters)
SCPI, Command
Types
Device-specific, command or query.
Example:
*RST; FREQ:IMOD:LTON PORT,1
Select port 1 as a source port for the lower tone.
FREQ:IMOD:UTON PORT,3
Select port 3 as a source port for the upper tone.
FREQ:IMOD:TTO EDEV
Select Extenal Device as a source port for the two tone signal.
FREQ:IMOD:REC 2
Select port 2 as the receiver port for the intermodulation measurement.