R&S ZVB - Page 925

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 910
instruments equipped with the necessary options).
...
(Perform mixer delay measurement, evaluate results.)
FREQ:MDELay:CONV OFF
Disable mixer delay measurement, switch back to normal (non frequency-
converting) mode.
[SENSe<Ch>:]FREQuency:MDELay:CDELay <Delay>
Enables constant mixer delay and defines a constant mixer delay value, to be used as a reference for a
mixer delay measurement calibration.
<Ch>
Channel number. If unspecified the numeric suffix is set to 1.
<Delay>
Constant delay
Range [def. unit]
0 s to 0.001 s [s]
*RST value
0 s
SCPI, Command
Types
Device-specific, command or query.
Example:
*RST; :FREQ:MDEL:CDEL 1 ns
Enable constant mixer delay and define a constant mixer delay value of 1
ns.
FREQ:MDEL:CDM?
Query whether the constant delay mode is active. The response is 1.
[SENSe<Ch>:]FREQuency:MDELay:CDMode <Boolean>
Selects constant or variable delay for the mixer delay calibration.
<Ch>
Channel number.
<Boolean>
ON – Constant delay
OFF – Variable delay
*RST value
ON
SCPI, Command Types
Device-specific, command or query.
Example:
See [SENSe<Ch>:]FREQuency:MDELay:CDELay
[SENSe<Ch>:]FREQuency:MDELay:COMBiner[:STATe] <Boolean>
Enables or disables the internal combiner
- for network analyzers R&S ZVA connected to an Extension Unit R&S ZVAX24 or R&S ZVAX-TRM with
installed combiner option
- for network analyzers R&S ZVT connected to an Extension Unit R&S ZVAX-TRM with installed combiner