R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 918
-3.4028234664E+038 W/V to +3.4028234664E+038 W/V [W/V].
Device-specific, command or query
*RST; CALC:PAR:MEAS "TRC1", "PAE21"
Select the PAE as a measurement parameter for the default trace Trc1. Select
port 1 as the DUT input port, port 2 as the DUT output port.
PAE:EXPR CK11
Select the test model involving both constants and no power approximation.
PAE:C 10; K 1
Set the constant c = U
DC
/ R to 10 W/V and the constant k = 1 W/V
2
. If the test
setup is in accordance with the settings made, the trace shows the PAE for a
constant DC supply voltage U
DC
.
[SENSe<Chn>:]PAE:EXPRession C10 | C1 | K101 | CK11
Selects the test model for the PAE measurement.
Channel number used to identify the active trace.
The DC power is equal to the constant c ([SENSe<Chn>:]PAE:C) times the DC
voltage measured at the DC input DC MEAS –10 V...+10 V.
The DC power is equal to the constant c times the DC voltage measured at the DC
input DC MEAS –1 V...+1 V.
The DC power is equal to the constant k ([SENSe<Chn>:]PAE:K) times the DC
voltage measured at the DC input DC MEAS –10 V...+10 V times the DC voltage
measured at the DC input DC MEAS –1 V...+1 V.
The DC power is equal to the constant c times the DC voltage measured at the DC
input DC MEAS –1 V...+1 V minus k times the square of the DC voltage measured
at the DC input DC MEAS –1 V...+1 V.
Device-specific, command or query
[SENSe<Chn>:]PAE:K <numeric_value>
Defines the constant k for the PAE measurement.
Channel number used to identify the active trace.
Value of the constant k in the PAE test model
([SENSe<Chn>:]PAE:EXPRession). The value is used if one of the test
models K101 | CK11 is selected.
-3.4028234664E+038 W/V
2
to +3.4028234664E+038 W/V
2
[W/V
2
].
To Next Page
Loading...
