R&S ZVB - Page 942

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 927
SCPI,
Command
Types
Device-specific, command or query
Example:
See [SENSe<Ch>:]PULSe:GENerator<gen_no>:TRAin:DATA
[SENSe<Ch>:]PULSe:GENerator<gen_no>:TRAin:SEGMent<Seg>:COUNt?
Queries the number of pulse train segments.
<Ch>
Channel number
<gen_no>
Number of the pulse generator signal. This suffix must be set to 1, since the
command affects the pulse generator signal only.
<Seg>
Pulse train segment number. This suffix is ignored; the command counts all
segments.
Response
0 | 1 | ...- number of (active or inactive)) pulse train segments.
*RST value
0
SCPI,
Command
Types
Device-specific, query only.
Example:
See [SENSe<Ch>:]PULSe:GENerator<gen_no>:TRAin:DATA
[SENSe<Ch>:]PULSe:GENerator<gen_no>:TRAin:SEGMent<Seg>:STARt <Start
High>
Changes the start time of a pulse train segment. A range must be created first to enable this command
(see [SENSe<Ch>:]PULSe:GENerator<gen_no>:TRAin:DATA).
<Ch>
Channel number
<gen_no>
Number of the pulse generator signal. This suffix must be set to 1, since the
command affects the pulse generator signal only.
<Seg>
Pulse train segment number
<Start High>
Start time of segment.
Range [def. unit]
0 s to 54975.5813622 s [s]
*RST value
0 s (no pulse train segment defined after *RST)
SCPI,
Command
Types
Device-specific, with query.
Example:
See [SENSe<Ch>:]PULSe:GENerator<gen_no>:TRAin:DATA
[SENSe<Ch>:]PULSe:GENerator<gen_no>:TRAin:SEGMent<Seg>[:STATe]
<Boolean>
Set the pulse train segment no. <Seg> active or inactive.