R&S ZVB - Page 963

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT Command Reference
SCPI Command Reference
Operating Manual 1145.1084.12 – 30 948
[SENSe<Ch>:]SEGMent<Seg>:FREQuency:CENTer?
Returns the center frequency of sweep segment no. <Seg>.
<Ch>
Channel number
<Seg>
Sweep segment number
Response
Center frequency of the sweep.
Range [def. unit]
Depending on the instrument model [Hz].
*RST value
–
SCPI, Command
Types
Device specific, query only.
Example:
SEGM:INS 1MHZ, 1.5MHZ, 111, -21DBM, 0.5S, 0, 10KHZ
Create a sweep segment with a sweep range between 1.0 MHz and 1.5
MHz.
SEGM:FREQ:CENT?
Query the center frequency of the created segment. The response is
1.2500000000E+006.
Note: The frequency range of the sweep segment can be changed via
[SENSe<Ch>:]SEGMent<Seg>:FREQuency:STARt and
[SENSe<Ch>:]SEGMent<Seg>:FREQuency:STOP.
[SENSe<Ch>:]SEGMent<Seg>:FREQuency:SPAN?
Returns the span (width) of sweep segment no. <Seg>.
<Ch>
Channel number
<Seg>
Sweep segment number
Response
Frequency span of the sweep.
Range [def. unit]
Depending on the instrument model [Hz].
*RST value
–
SCPI, Command
Types
Device specific, query only.
Example:
SEGM:INS 1MHZ, 1.5MHZ, 111, -21DBM, 0.5S, 0, 10KHZ
Create a sweep segment with a sweep range between 1.0 MHz and 1.5
MHz.
SEGM:FREQ:SPAN?
Query the span of the created segment. The response is
5.0000000000E+005.
Note: The frequency range of the sweep segment can be changed via
[SENSe<Ch>:]SEGMent<Seg>:FREQuency:STARt and