SPECIFICATIONS 26 July 2002
Spec-2
Zoom: 25% to 400% in 1% steps (Platen mode)
25% to 200% in 1% steps (ADF mode)
Scanning System: 3-line 1-chip CCD sensor (600 dpi)
Light Source: 1 xenon lamp
Photoconductor: OPC belt
Charging: Corona wire with grid plate
Print System: Two laser beam, 600 dpi
Development System: Mono component toner
Transfer: Image transfer: Transfer belt with bias roller
Paper transfer: Roller
Separation: Discharge pin
Fusing: Heating rollers and fusing belt
Cleaning: OPC belt: Blade
Image transfer belt: Cleaning brush
Quenching: Lamp
Toner Supply: Cartridge
Power Source:
Voltage Frequency Amperage
NA 120 V 60 Hz 12 A
EU & Asia 220 to 240 V 50/60 Hz 8 A
Power Consumption:
Mainframe only Full System
Maximum: Less than 1.5 kW Less than 1.5 kW
Copying: Approx. 700 W Approx. 900 W
Warm-up: Less than 1.5 kW Less than 1.5 kW
Stand-by: Less than 200 W Less than 200 W
Energy Saver/
Auto Off:
10 W 10 W
NOTE: Full system: ARDF + 1 bin tray + Paper Tray Unit + Duplex Unit + Bridge
Unit +1000-sheet Finisher
Noise Emission:
Mainframe only Full System
Stand-by: Less than 45 dB (A) Less than 50 dB (A)
Copying: Less than 67 dB (A) Less than 70 dB (A)
NOTE: Full system: ARDF + 1 bin tray + Paper Tray Unit + Duplex Unit + Bridge
Unit +1000-sheet Finisher
Dimensions (W x D x H): 550 x 670 x 781 mm (21.65" x 26.37" x 30.74")
Weight: Less than 80 Kg (176 lb)
To Next Page
Loading...
