Rohde & Schwarz FSVA - Page 188

Instrument Functions
R&S
®
FSVA/FSV
188Operating Manual 1176.7510.02 ─ 09
Screen Colors ← Display Setup
Opens a submenu to configure the screen colors. For details on screen colors refer to
the Quick Start Guide, chapter 2 "Preparing for Use".
The submenu contains the following commands:
●
"Select Screen Color Set" on page 188
●
"Color (On/Off)" on page 188
●
"Select Object" on page 188
●
"Predefined Colors" on page 188
●
"User Defined Colors" on page 189
●
"Set to Default" on page 189
Remote command:
DISPlay:CMAP<item>:HSL on page 924
Select Screen Color Set ← Screen Colors ← Display Setup
Opens the "Select Screen Color Set" dialog box to select default or user defined color
settings.
If one of the default settings is selected ("Default Colors 1"/"2"), the default settings for
brightness, color tint and color saturation for all display screen elements are restored.
The default color schemes provide optimum visibility of all picture elements at an angle
of vision from above or below. Default setting is "Default Colors 1".
If "User Defined Colors" is selected, a user-defined color set can be defined. For step-
by-step instruction refer to the Quick Start Guide, chapter 2 "Preparing for Use".
Remote command:
DISPlay:CMAP<item>:DEFault on page 923
Color (On/Off) ← Screen Colors ← Display Setup
Switches from color display to black-and-white display and back. The default setting is
color display.
Select Object ← Screen Colors ← Display Setup
Opens the "Color Setup" dialog box to select the color settings for a selected object.
The "Selected Object" list is displayed to select the object. For setting the color the pre-
defined colors are displayed.
Remote command:
DISPlay:CMAP<item>:HSL on page 924
HCOPy:CMAP<item>:HSL on page 931
Predefined Colors ← Screen Colors ← Display Setup
In the "Color Setup" dialog box, displays the "Predefined Colors" (alternatively to the
"Predefined Colors" button). This softkey is only available if, in the "Select Color Set"
dialog box, the "User Defined Colors" option is selected or the "Color Setup" dialog box
is displayed. For further details refer to the Quick Start Guide, chapter 2 "Preparing for
Use".
Remote command:
DISPlay:CMAP<item>:PDEFined on page 924
HCOPy:CMAP<item>:PDEFined on page 932
General Settings, Printout and Instrument Settings