Rohde & Schwarz FSVA - Page 623

Remote Control
R&S
®
FSVA/FSV
623Operating Manual 1176.7510.02 ─ 09
If no next higher minimum value is found on the trace (level spacing to adjacent values
< peak excursion), an execution error (error code: -200) is produced.
In "Spectrogram" mode, this command positions the specified delta marker on the next
peak level of the x-axis. The search includes only the data to the right of the current
marker position in the current frame. It does not change the position of the delta
marker on the y-axis.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example:
CALC:DELT:MAX:RIGH
Sets delta marker 1 to the next smaller maximum value to the
right of the current value.
Manual operation: See "Next Mode" on page 304
CALCulate<n>:DELTamarker<m>:MINimum[:PEAK]
This command positions the delta marker to the current trace minimum. The corre-
sponding delta marker is activated first, if necessary.
In "Spectrogram" mode, this command positions the specified delta marker on the cur-
rent minimum level of the x-axis. The search is performed within a specific frame. It
does not change the position of the deltamarker on the y-axis.
Suffix:
<n>
.
Selects the measurement window.
<m> Selects the marker.
Example:
CALC:DELT3:MIN
Sets delta marker 3 to the minimum value of the associated
trace.
Manual operation: See "Min" on page 302
See "Marker Search Type" on page 306
CALCulate<n>:DELTamarker<m>:MINimum:LEFT
This command positions the delta marker to the next higher trace minimum on the left
of the current value (i.e. descending X values). The corresponding delta marker is acti-
vated first, if necessary.
If no next higher minimum value is found on the trace (level spacing to adjacent values
< peak excursion), an execution error (error code: -200) is produced.
In "Spectrogram" mode, this command positions the specified delta marker on the next
minimum level of the x-axis. The search includes only the data to the left of the current
marker position in the current frame. It does not change the position of the delta
marker on the y-axis.
Remote Control – Commands