Rohde & Schwarz R&S SMB100B - Page 204

File and data management
R&S
®
SMB100B
204User Manual 1178.3711.02 ─ 08
●
To access the general data list editor, use the"Edit" button
(see also Chapter 6.7, "List editor", on page 145).
●
To perform standard file management functions, like create directories, move, copy,
delete files and/or directories, use the standard "File Manager" function (see Chap-
ter 9.8, "Using the file manager", on page 209).
Remote command:
To list all files in a directory:
:MMEMory:CDIRectory on page 363
:MMEMory:CATalog? on page 362
[:SOURce]:CORRection:CSET:CATalog? on page 451
Recent files
Displays the files last used.
Show SCPI List
Opens the "SCPI List", which lists the current settings of the R&S SMB100B as SCPI
commands.
The R&S SMB100B provides this function for Operation Mode > SCPI-Export.
SCPI List
Contains a list of all SCPI commands corresponding to the current instrument settings.
See also "How to create a SCPI list with the current instrument settings in one step"
on page 337
Save
Saves the current instrument settings under the defined filename.
Remote command:
:MMEMory:STORe:STATe on page 366
Save Immediate x
Stores the current instrument setting in one of the intermediate memories.
These instrument settings are retained until a different instrument setting is stored in
the intermediate memory. When the instrument is switched off, the contents of the
intermediate memories are retained.
Remote command:
*SAV on page 354
Exclude Frequency
The current frequency is retained when a stored instrument setting is loaded.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed]:RCL on page 456
Exclude Level
The current level is retained when a stored instrument setting is loaded.
Remote command:
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:RCL on page 498
Saving and recalling instrument settings