Rohde & Schwarz R&S SMB100B - Page 496

Remote control commands
R&S
®
SMB100B
496User Manual 1178.3711.02 ─ 08
*RST: CW
Example: See Example"Setup an RF frequency or power sweep"
on page 506
Manual operation: See "State (RF level sweep)" on page 129
See "State (RF frequency / level sweep)" on page 130
[:SOURce<hw>]:POWer:POWer <Power>
Sets the level at the RF output connector.
This value does not consider a specified offset.
The command [:SOURce<hw>]:POWer[:LEVel][:IMMediate][:AMPLitude]
sets the level of the "Level" display, that means the level containing offset.
See "RF frequency and level display with a downstream instrument" on page 59.
Parameters:
<Power> float
Level at the RF output, without level offset
Range: See data sheet
Increment: 0.01
Default unit: dBm
Example:
SOURce1:POWer:POWer 15
Sets the level at RF output
Manual operation: See "Amplitude" on page 64
See "Used SMBB Settings For Measurement" on page 165
[:SOURce<hw>]:POWer:STARt <Start>
[:SOURce<hw>]:POWer:STOP <Stop>
Sets the RF start/stop level in sweep mode.
Parameters:
<Stop> float
Sets the setting range calculated as follows:
(Level_min + OFFSet) to (Level_max + OFFSet)
Where the values are set with the commands:
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet
[:SOURce<hw>]:POWer:STARt
[:SOURce<hw>]:POWer:STOP
Range: Minimum level to maximum level
*RST: -30 (Start)/ -10 (Stop)
Default unit: dBm
Example: See Example"Setup an RF frequency or power sweep"
on page 506
Manual operation: See "Start Level / Stop Level" on page 137
SOURce subsystem