Rohde & Schwarz R&S SMB100B - Page 539

Remote control commands
R&S
®
SMB100B
539User Manual 1178.3711.02 ─ 08
:SYSTem:NTP:HOSTname <NTPName>
Sets the address of the NTP server. You can enter the IP address, or the hostname of
the time server, or even set up an own vendor zone. See the Internet for more informa-
tion on NTP.
Parameters:
<NTPName> string
Manual operation: See "NTP Address" on page 593
:SYSTem:NTP:STATe
<UseNtpState>
Activates clock synchronization via NTP.
Parameters:
<UseNtpState> 1 | ON | 0 | OFF
*RST: n.a. (factory preset: 0)
Example: See Example"Configuring date and time" on page 519.
Manual operation: See "NTP Address" on page 593
:SYSTem:TIME <Hour>, <Minute>, <Second>
Queries or sets the time for the instrument-internal clock.
This is a password-protected function. Unlock the protection level 1 to access it.
Parameters:
<Hour> integer
Range: 0 to 23
<Minute> integer
Range: 0 to 59
<Second> integer
Range: 0 to 59
Example: See Example"Configuring date and time" on page 519.
Manual operation: See "Time" on page 593
:SYSTem:TIME:ZONE <TimeZone>
Sets the timezone. You can query the list of the available timezones with :SYSTem:
TIME:ZONE:CATalog?.
Parameters:
<TimeZone> string
Example: See Example"Configuring date and time" on page 519.
Manual operation: See "Timezone" on page 593
SYSTem subsystem