Rohde & Schwarz R&S SMB100B - Page 593

Maintenance, storage and disposal
R&S
®
SMB100B
593User Manual 1178.3711.02 ─ 08
Settings:
Date.............................................................................................................................593
Time............................................................................................................................ 593
Timezone.....................................................................................................................593
Time Protocol.............................................................................................................. 593
NTP Address...............................................................................................................593
Date
Displays the date set in the operating system in the format [yyyy.mm.dd].
Remote command:
:SYSTem:DATE on page 538
Time
Displays the time set in the operating system in the format [hh.mm.ss].
The time setting corresponds to the selected Timezone.
Remote command:
:SYSTem:TIME on page 539
Timezone
Selects the timezone in the date and time settings of the operating system.
You can select the timezone according to the major cities on the respective continents.
Tip: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
Remote command:
:SYSTem:TIME:ZONE on page 539
:SYSTem:TIME:ZONE:CATalog? on page 540
Time Protocol
Enables the instrument to refer to a network time protocol.
A network time protocol synchronizes the system clocks of all participating devices in a
computer network (Ethernet). A time server in the network provides the time base for
the connected devices that refer to this time to synchronize events.
You can select a high-precision time protocol to achieve high clock accuracy and thus
reduce the impact of varying network delays.
"None"
Refers to the selected timezone, see Timezone.
"NTP"
Uses the network time protocol (NTP).
Remote command:
:SYSTem:TIME:PROTocol on page 540
NTP Address
Sets the IP address or host name of the NTP server.
When the server is detected and verified, the instrument enables the connection auto-
matically.
Performing maintenance tasks