Maintenance, storage and disposal
R&S
®
SMB100B
594User Manual 1178.3711.02 ─ 08
Remote command:
:SYSTem:NTP:HOSTname on page 539
:SYSTem:NTP:STATe on page 539
15.3.2.2 How to set date and time
To select the timezone
1. Press the [Setup] key.
2. Select "Maintenance > Date /Time > Timezone".
3. Select continent and city of your location.
Tip: By typing the first letter, you can quickly navigate through the lists to find the
desired destination.
4. Close the dialogs.
The instrument adjusts the time according to the selected location.
To set the date and time
1.
NOTICE!
This function is password-protected. Unlock the protection level 1 to access it.
Since the date and time settings affect time-based options, changing the date and
time can therefore lead to loss of access to the function of the options. We recom-
mend that you only change the system time in urgent cases.
If the time is not displayed correctly, the internal CMOS battery can be discharged.
To change the battery, contact your Rohde & Schwarz support center at
www.rohde-schwarz.com/support.
Press the [Setup] key.
2. Select "Security > Protection".
3. Enable the "Protection Level 1".
The default password is 123456.
4. Select "Setup > Maintenance > Date / Time".
5. Adjust the settings.
6. Close the dialogs.
The instrument sets the new date and time.
15.3.3 Check front panel
Within this dialog, you can verify the functionality of the control keys.
How To: See Chapter 15.3.3.2, "How to test the front panel", on page 595
Performing maintenance tasks
To Next Page
Loading...
