Rohde & Schwarz R&S SMB100B - Page 595

Maintenance, storage and disposal
R&S
®
SMB100B
595User Manual 1178.3711.02 ─ 08
15.3.3.1 Check front panel settings
Access:
► Select "System Config > Setup > Maintenance > Check Front Panel".
Reflecting the front panel, the "Check Front Panel" dialog contains all functions to
test the operating elements of the instrument.
15.3.3.2 How to test the front panel
See:
●
"Testing the key panel" on page 595
●
"Testing the touchscreen" on page 596
●
"Terminating the test" on page 597
●
"Debugging" on page 597
Testing the key panel
To perform the key panel test, you operate the keys at the front panel, and check the
response of the instrument in the "Check Front Panel" dialog. To perform this test prop-
erly, check each key of the front panel. The test is only completed, when you have veri-
fied all keys.
During the test, the actual functions of the keys are disabled.
1. Press the [Setup] key.
2. Select "Maintenance > Check Front Panel"
Performing maintenance tasks