Instrument Function
R&S
®
SMBV100A
280Operating Manual 1176.8016.02 ─ 17
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:EXECute on page 808
:TRIGger<hw>:FSWeep[:IMMediate] on page 844
:TRIGger<hw>[:SWEep][:IMMediate] on page 848
Reset Sweep - Frequency Sweep
Resets the sweep.
With the next trigger event, the sweep starts with at the initial value.
Remote command:
[:SOURce<hw>]:SWEep:RESet[:ALL] on page 817
Start Freq - Frequency Sweep
Sets the start frequency.
Remote command:
[:SOURce<hw>]:FREQuency:STARt on page 740
Stop Freq - Frequency Sweep
Sets the stop frequency.
Remote command:
[:SOURce<hw>]:FREQuency:STOP on page 740
Center Freq - Frequency Sweep
Sets the center frequency.
Remote command:
[:SOURce<hw>]:FREQuency:CENTer on page 735
Span - Frequency Sweep
Sets the span.
Remote command:
[:SOURce<hw>]:FREQuency:SPAN on page 739
Current Freq - Frequency Sweep
Displays the current frequency.
In sweep "Step" mode, the parameter is editable and you can enter frequency for the
next step.
Remote command:
[:SOURce<hw>]:FREQuency:MANual on page 737
Spacing - Frequency Sweep
Selects the mode for the calculation of the frequency sweep intervals.
"Linear"
Takes the frequency value entered as an absolute value in Hz.
"Logarithmic"
Takes the value entered as a lograithmic value, that means as a con-
stant fraction of teh current frequency in %.
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing on page 811
RF Block
To Next Page
Loading...
