Instrument Function
R&S
®
SMBV100A
389Operating Manual 1176.8016.02 ─ 17
The "Trigger In" section is where the trigger for the signal is set. Various parameters
will be provided for the settings, depending on which trigger source - internal or exter-
nal - is selected. The current status of signal generation ("Running" or "Stopped") is
indicated for all trigger modes.
The "Next Segmet Trigger In" is where the segment triggering is configured. This sec-
tion is enabled only for multi segment waferoms.
The "Marker Mode" section is where the marker signals at the MARKER output con-
nectors are configured.
The "Marker Delay" section is where a marker signal delay can be defined, either with-
out restriction or restricted to the dynamic section, i.e., the section in which it is possi-
ble to make settings without restarting signal and marker generation.
The "Clock Settings" section is where the clock source is selected and - in the case of
an external source - the clock type.
Baseband Signal - Baseband Block
To Next Page
Loading...
