Instrument Function
R&S
®
SMBV100A
388Operating Manual 1176.8016.02 ─ 17
Trigger/Marker
Calls the Trigger and Marker menu.
This menu is used to select the trigger source, set the time delay on an external trigger
signal and configure the marker output signals (see "Trigger/Marker/Clock Settings"
on page 388).
Remote command:
n.a.
Execute Trigger
Executes trigger manually. A manual trigger can be executed only when an internal
trigger source and a trigger mode other than Auto are selected.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TRIGger:EXECute on page 605
Clock
Calls the "Clock" menu. The "Clock" menu is used to select the clock source (see
"Clock Settings" on page 402).
Remote command:
n.a.
Create Test Signal...
Selects the form of the test signal and calls the menu for generating it. A sinusoidal,
rectangular or test signal with constant I/Q can be selected.
See the corresponding section for detailed description of the parameters for the
selected test signal:
●
"Sine Test Signals" on page 404
●
"Rect Test Signal" on page 405
●
"Const IQ Test Signal" on page 406
Remote command:
n.a.
Multi Segment
Calls the menu for calculating multi segment waveforms (see Chapter 5.9.4.3, "Multi
Segment Waveforms", on page 407).
Remote command:
n.a.
Multi Carrier
Calls the menu for calculating multi carrier waveforms (see Chapter 5.9.4.4, "Multi Car-
rier Waveforms", on page 423).
Remote command:
n.a.
Trigger/Marker/Clock Settings
To access this dialog, select "Main Menu > Trigger/Marker".
Baseband Signal - Baseband Block
To Next Page
Loading...
