Instrument Function
R&S
®
SMBV100A
430Operating Manual 1176.8016.02 ─ 17
"Peak"
The individual carriers are leveled based on their peak power and the
configured "Carrier Gain".
Example:
A multi carrier signal is composed from two waveform files.
First carrier "Gain" = 0 dB
Second carrier "Gain" = -3 dB
In the resulting multi carrier signal, the peak power of the second car-
rier signal will be 3 dB lower than the peak power of the first carrier
signal.
Example: Multi carrier signal composed of waveforms with dif-
ferent crest factor
A multi carrier signal is composed from two waveform files with the
following characteristics:
3GPP FDD signals with the same "Sample Rate" but different "Crest
Factors".
"Peak" = 0 dBFS
"Carrier Gain" = 0 dB
The Peak values of the carrier signals are equal, the RMS values are
different.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:MCARrier:POWer:REFerence on page 622
Carrier Table
Calls the table for configuring individual carriers. A selectable carrier range can be set
with the aid of the optional "Carrier Table Assistant" (see "Muti Carrier Table"
on page 432).
The multi carrier configuration can be checked with the aid of the "Carrier Graph".
Baseband Signal - Baseband Block
To Next Page
Loading...
